Heat pumps are a very effective tool that is used by businesses all over the country. However, like any piece of machinery, they are not infallible. There will be a number of problems that can develop with your heat pump, which require you to have some understanding of the basic issues that afflict this particular type of technology.

Let’s take a look at some of the best heat pump problems solutions. Luckily, there are many easy fixes to a lot of common heat pump industrial problems, so you don’t have to panic.

Suddenly Losing Heat

One of the most typical problems that can affect any heat pump is that it will suddenly stop producing heat. Understandably, this is a great source of concern because what if the heat pump has broken entirely? Would you then have to replace the entire pump and start again?

The first thing you need to do is not panic. It’s possible that the heat pump wasn’t turned on properly, or has been turned off by mistake, so look at that. Second of all, check your circuit breaker. It’s possible that something in the building has tripped the electrical system, which will affect the pump itself.

Not Enough Heat is Produced

If there is not enough heat being produced by your pump, it would be wise to check the airflow and make sure that it is not clogged. Reduced airflow can have an impact on the performance of the system, and you should also check the thermostat. In some cases, a damaged thermostat means that the air being produced isn’t reaching the correct temperature. If you ever need to replace the system because it’s just not up to snuff, check out the Grundfos Magna1 25-100.

Cold Air Blowing

If you suddenly experience cold air, the best thing you can do is wait to see if the air manages to warm back up. In some cases, a heat pump will cycle back into a colder air pattern for a few minutes to warm up the system, especially after a cold spell. Therefore, if the cold air is only temporary, then it’s just a cycle built into the heat pump.

However, if the cold air isn’t stopping, the issue can be mechanical in nature, and you’ll need to experiment with the thermostat a little to see if it’s the problem. A broken temperature reading can negatively impact the air you get. You should also check for signs of damage to the wiring because it can have a big impact on your system.

Incorrect Cycling

If your heat pump industrial isn’t working right and is cycling over and over, then it could be overheating. This can be the fault of a blower which is malfunctioning or even the air filter becoming clogged. If you want to prevent this problem from occurring, you should try cleaning or changing your air filter outright.

There can be other issues to consider, of course. For example, the thermostat can be damaged – it’s responsible for a lot of issues with an air pump – and may need to be replaced. Check the batteries first to see if it’s an easy fix before you get the professionals in.

If your heat pump is constantly running, then the thermostat can be set too high and needs to be brought down a little. In a very cold environment, the heat pump needs to work harder than usual to generate heat. If you need a workhorse, we recommend the Grundfos Magna1 50-150 F.

Strange Noises

Strange noises are an issue for a lot of heat pumps, and they can be for a range of different reasons which aren’t exactly clear to most. You’ll need to experiment and take a look at the problem. The best thing you can do is cycle through the likely culprits – cleaning the filter, checking airflow, making sure there are no obvious damages, etc.

If the sounds persist, you may need to repair the system or replace it entirely. We recommend the Grundfos Magna1 25-60 as a good all-around replacement, if you need one.

Final Thoughts

You’ll run into a lot of heating pump problems when you have a system that works full time to deliver heat to a commercial building – you’ll need to learn how to diagnose and fix basic problems like these because most aren’t that complicated. The best thing that you can do is fix these issues yourself, because most can be solved with minimal effort.

However, if you do encounter a problem that you don’t recognise, the best thing you can do is contact a professional. It’s best to get it repaired and sorted by a trained expert.